Installation Guide

If copying/pasting, eye-drop this text to
ensure a uniform look for all installation
paragraphs.
02/18/09
55528
HYUNDAI TUCSON
1. Open the hatch and remove the vehicles
taillight housings by removing the two
phillips head screws. Seperate the
vehicles connector from the back of the
taillight housing.
2. On the drivers side route the T-Connector
end with the yellow wire up thru the
opening under the taillight housing.
Insert in-between the seperated
connectors.
3. Route the T-connector end with the green
wire along the back side of the bumper to
the passenger side. Repeat step 2 on the
passenger side using the green wire.
4. Locate a suitable grounding point near
the connector such as an existing screw
with nut in the vehicle’s frame or drill a
3/32” hole and secure white wire using
eyelet and screw provided.
5. Adhere the black converter box to the
frame of the car using the double-sided
tape provided. Secure any loose parts of
the T-connector with the cable ties
provided.
6. Route the 4-flat to the center of the
vehicle and secure in a convenient out of
the way location.
WARNING!
Verify miscellaneous items that may be
hidden behind or under any surface before
drilling to avoid damage and/or personal
injury.