Installation Guide

A B
Step 1
Locate the vehicle connector. It will be located on the
passenger side between the bumper and rear tire. Remove the
protective cover taking care to damage the locking tabs. (A,B)
Step 2
Insert the custom wiring harness into the
vehicle connector. Make sure the connectors
are fully inserted with locking tabs in place.
Step 3
Locate a suitable grounding point near the connector such as
an existing screw with nut in the vehicle frame or drill a 3/32"
pilot hole for the provided screw. The area should be free of
rust, dirt and paint. Secure the white ground wire using the ring
terminal and provided screw.
WARNING: Check for miscellaneous items that may be
hidden behind or under any surface before drilling to avoid
damage and / or personal injury.
Step 4
Locate a flat spot inside the vehicle, near the taillight. Adhere
the black converter box using the provided double-sided tape.
Step 5
When in use, route the 4-flat to the center of the vehicle and out
of the trunk. When not in use, roll up and store in a convenient,
out of the way location inside the trunk. Secure any loose wires
with the provided cable ties.
Step 6
Reinstall all items removed during install. Install the
provided 4-flat dust cover to help prevent corrosion.
INSTALLATION
/
SAFETY INSTRUCTIONS
55529-INS-RA • PAGE 2