Installation Guide

I J
INSTALLATION
/
SAFETY INSTRUCTIONS
Step 7
Reseat the grommet and use the provided sealant
to seal the cut in the grommet and around all the wires.
Step 8
On the driver side, behind the rubber grommet, locate the 2-pin
connector. It will be similar to the one on the custom wiring
harness. Unwrap the foam from the connector and insert the
connector into the vehicle connector making sure the connector
is fully inserted with the locking tabs in place (I).
Step 9
Locate a flat spot inside the vehicle, near the taillight. Adhere
the black converter box using the provided double-sided tape.
Step 10
2004-2006 Pacifica only
In the engine compartment, locate the vehicle fuse box. It will be
on the driver side near the battery. Insert the provided 20-amp
fuse into position 10 in the fuse box, labeled 'TRAILER / TOW' (J).
Step 11
When in use, route the 4-flat to the center of the vehicle and out
of the trunk. When not in use, roll up and store in a convenient,
out of the way location inside the trunk. Secure any loose wires
with the provided cable ties.
Step 12
Reinstall all items removed during install. Install the
provided 4-flat dust cover to help prevent corrosion.
PAGE 3 • 55530-INS-RB