Installation Guide

A B C
D E F
Step 1
Remove the two bolts securing the taillight assembly. Carefully
remove the taillight by pulling rearward (A). Repeat this on the
other side of the vehicle.
Step 2
Remove the three cargo bolts securing the rear threshold.
Carefully pry the threshold away from the vehicle (B,C).
Step 3
Pull back on the driver side trim panel. Take care
not to damage the alignment tabs on the back (D).
Step 4
On passenger side, open the vehicle jack storage compartment
to expose the opening to the taillight assemblies (E).
Step 5
From the driver side, route the custom wiring harness end with
yellow wire out from inside the vehicle through the taillight
opening. Separate the connectors from the taillight housing
taking care not to damage the locking tabs.
Step 6
Insert the custom wiring harness end with yellow wire between
the separated connectors. Make sure the connectors are fully
inserted with locking tabs in place (F).
Step 7
Locate a suitable grounding point near the connector such as
an existing screw with nut in the vehicle frame or drill a 3/32"
pilot hole for the provided screw. The area should be free of
rust, dirt and paint. Secure the white ground wire using the ring
terminal and provided screw.
WARNING: Check for miscellaneous items that may be
hidden behind or under any surface before drilling to avoid
damage and / or personal injury.
Step 8
Route the custom wiring harness end with the green wire to
the passenger side under the removed threshold cover. Repeat
steps 5-6 on the passenger side using the harness end with the
green wire.
Step 9
Locate a flat spot inside the vehicle, near the taillight. Adhere
the black converter box using the provided double-sided tape.
Step 10
Reinstall all items removed during install. Install the
provided 4-flat dust cover to help prevent corrosion.
INSTALLATION
/
SAFETY INSTRUCTIONS
55580-INS-RA • PAGE 2