Installation Guide

INSTALLATION INSTRUCTIONS

CUSTOM WIRING HARNESS

WIRING LOCATION GUIDEAPPLICATIONS

NOTICE

WARNING

TOOLS NEEDED

Exceeding the product rating can cause loss of warranty,

overheating and potential fire. Do not exceed product rating

or tow vehicle lamp load rating, whichever is lower.

Make Model

Honda Ridgeline

WARNING: DO NOT EXCEED PRODUCT RATING OR TOW VEHICLE LAMP LOAD RATING, WHICHEVER IS LOWER

PICKUP TRUCKS

(

)

Representative vehicle shown below

T1 - Behind driver side taillight housing

T2 - Behind passenger side taillight housing

T2T1

All steps must be followed to ensure the wiring harness

will function properly. Once installed, test for proper function

by using a test light or connecting a properly wired trailer.

Signal Circuits - 3.0 amps per side

Tail / Running Circuits - 6.0 amps total

Check vehicle owner's manual or contact

the vehicle manufacturer for more information.

Ratchet

10mm socket

Panel trim removal tool

PAGE 1 • 55585-INS-RA

PAGE 1
INSTALLATION INSTRUCTIONS WARNING: DO NOT EXCEED PRODUCT RATING OR TOW VEHICLE LAMP LOAD RATING, WHICHEVER IS LOWER APPLICATIONS Make Model Honda Ridgeline WIRING LOCATION GUIDE PICKUP TRUCKS (T) Representative vehicle shown below T1 - Behind driver side taillight housing T2 - Behind passenger side taillight housing CUSTOM WIRING HARNESS T1 T2 NOTICE All steps must be followed to ensure the wiring harness will function properly.
PAGE 2
INSTALLATION / SAFETY INSTRUCTIONS Step 1 Open the vehicle tailgate. Remove the 10mm bolts securing the taillights (A). Carefully pull rearward on the taillight assembly taking care not to damage the alignment tabs on the back (B). Step 2 Behind the removed taillights locate the vehicle taillight wiring harness connectors (C). The connectors will be similar to those on the custom wiring harness. Separate the connectors from the taillight housing taking care not to damage the locking tabs.