Installation Guide

HONDA INSTALLATION
H
G I
J K L
M
Step 1
Locate the vehicle battery on the driver side under the
hood and disconnect the negative battery terminal.
Step 2
Open the vehicle trunk and remove the cargo area cover.
Step 3
On the driver side, remove the 10mm bolts
holding the cargo tray in place (G,H).
Step 4
Locate the vehicle connector on the driver side, in the corner
under the trim panel (I). The connector will be similar to that on
the custom wiring harness.
Step 5
Insert the custom wiring harness connector into the vehicle
connector. Make sure the connectors are fully inserted with
locking tabs in place (J).
WARNING: Check for miscellaneous items that
may be hidden behind or under any surface before
drilling to avoid damage and / or personal injury.
Step 6
Locate a flat spot outside the vehicle, on the frame. Adhere the
black converter box using the provided double-sided tape (K).
Step 7
On the driver side, under the hood, near the firewall, locate the
vehicle fuse box (L). Remove the fuse panel cover and locate
the trailer tow fuse at position 10. Insert the provided 10 amp
fuse into fuse location (M).
Step 8
When in use, route the 4-flat to the center of the vehicle.
When not in use, roll up and store in the spare tire storage area.
Secure any loose wires with the provided cable ties.
Step 9
Reinstall all items removed during install and reconnect
negative battery terminal. Install the provided 4-flat dust cover
to help prevent corrosion.
PAGE 3 • 56008-INS-RB