Installation Guide

1. Open the rear hatch. Using a screwdriver,
remove the two plastic fasteners securing
each taillight housing (A). Remove the
taillight housings by pulling out on the
taillights taking care not to damage the
alignment tabs (B).
2. Starting on the driver’s side separate the
vehicle’s taillight wiring harness from the
back of the taillight taking care not to
damage the allignment tabs (C). Insert the
T-Connector end with the yellow wire
between the separated connectors. Make
sure the connectors are fully inserted with
locking tabs in place.
3. Route the T-Connector end with the
green wire down through the opening
under the taillight assembly (D). Route the
T-Connector end with the green wire under
the vehicle along the backside of the
bumper to the passenger side and up to
the passenger side taillight housing through
the opening on the passenger side. Repeat
Step 2 on the passenger side using the
T-Connector end with the green wire.
WARNING!
Verify miscellaneous items that may be
hidden behind or under any surface before
drilling to avoid damage and/or personal
injury.
4. Locate a suitable grounding point near
the connector such as an existing screw
with nut in the vehicle’s frame or drill a
3/32” hole and secure white wire using
eyelet and screw provided.
5.Route the 4-flat to the center of the
vehicle and secure in a convenient out of
the way location. Secure any loose wires
with the cable ties provided.
11/17/2010
56009
JEEP GRAND CHEROKEE
INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT 1-877-287-8634