Installation Guide

A B C
D E
Step 1
Open the rear cargo doors. Locate and remove the eight Phillips
screws securing the rear scuff panel. Remove the scuff panel by
pulling out on the bottom and then up. Take care not to damage
the alignment tabs on the back (E).
Step 2
Starting on the driver side, remove the four T-15 Torx screws
securing the taillight assembly (A). Behind the taillight locate the
vehicle taillight wiring harness connectors (B). The connectors
will be similar to those on the custom wiring harness. Separate
the connectors from the taillight housing taking care not to
damage the locking tabs. Repeat this step for the passenger side.
Step 3
Locate the grommet behind the taillight where the vehicle
taillight wiring passes though from inside the cabin to the
taillight. Remove the grommet and cut a slit large enough
to route the custom wiring harness though (C,D).
Step 4
Route the custom wiring harness end with the yellow wire
out through the grommet opening and though the slit in the
grommet. Insert the wiring harness end with yellow wire
between the separated connectors. Make sure the connectors
are fully inserted with locking tabs in place.
Step 5
Reseat the grommet using the provided sealant
to seal the cut in the grommet and around all the wires.
Step 6
Route the custom wiring harness end with the yellow wire down
along the inside body panel and under the removed scuff panel
to the driver side. Repeat steps 3-4 on the passenger side using
the harness end with the green wire.
Step 7
When in use, route the 4-flat to the center of the vehicle and out
of the trunk. When not in use, roll up and store in a convenient,
out of the way location inside the trunk. Secure any loose wires
with the provided cable ties.
Step 8
Reinstall all items removed during install. Install the
provided 4-flat dust cover to help prevent corrosion.
INSTALLATION
/
SAFETY INSTRUCTIONS
56020-INS-RB • PAGE 2