Installation Guide

A B C
D E
Step 1
Locate vehicle battery on the driver side under the
hood and disconnect the negative battery terminal.
Step 2
Nissan Rogue
Open the vehicle trunk. Remove the rear scuff panel,
storage covers and floor coverings (A).
Infiniti G25 / G35 / G37
Open the vehicle tailgate. Remove the rear scuff panel.
Step 3
Nissan Rogue
Remove the fasteners securing the rear trim panels on the driver
and passenger sides (B). Remove the trim panels to locate the
vehicle taillight wiring harness connectors. The connectors will
be similar to those on the custom wiring harness. Separate the
connectors from the taillight housing taking care not to damage
the locking tabs (C).
Infiniti G25 / G35 / G37
Pull back on the felt liner to locate the vehicle taillight wiring
harness connectors. The connectors will be similar to those
on the custom wiring harness. Separate the connectors from the
taillight housing taking care not to damage the locking tabs (D,E).
Step 4
On the driver side, insert the custom wiring harness end with
yellow wire between the separated connectors. Make sure the
connectors are fully inserted with locking tabs in place.
Step 5
Route the custom wiring harness end with the green wire to the
passenger side behind the removed scuff panels. Repeat step 4
on the passenger side using the harness end with the green wire.
Step 6
Locate a suitable grounding point near the connector such as
an existing screw with nut in the vehicle frame or drill a 3/32"
pilot hole for the provided screw. The area should be free of
rust, dirt and paint. Secure the white ground wire using the ring
terminal and provided screw.
WARNING: Check for miscellaneous items that may be
hidden behind or under any surface before drilling to avoid
damage and / or personal injury.
Step 7
Locate a flat spot inside the vehicle, near the taillight. Adhere
the black converter box using the provided double-sided tape.
Step 8
Route the black power wire from the vehicle battery
as shown on the included CME-PCL-INS sheet.
Step 9
Reinstall all items removed during install and reconnect
negative battery terminal. Install the provided 4-flat dust
cover to help prevent corrosion.
INSTALLATION
/
SAFETY INSTRUCTIONS
56033-INS-RB • PAGE 2