Installation Guide

A B C
Step 1
Open the vehicle tailgate. Remove the access door on the
driver side rear scuff panel (A). Open the rear storage door
and remove storage tray and jack storage door. Pull back
on the cargo liner (B).
Step 2
Route the driver side vehicle wiring connector under the trim
panel up to the junction box inside the removed access door.
Insert the custom wiring connector into the receptacle in the
junction box (C).
Step 3
Locate a suitable grounding point near the connector such as
an existing screw with nut in the vehicle frame or drill a 3/32"
pilot hole for the provided screw. The area should be free of
rust, dirt and paint. Secure the white ground wire using the ring
terminal and provided screw.
WARNING: Check for miscellaneous items that may be
hidden behind or under any surface before drilling to avoid
damage and / or personal injury.
Step 4
Locate a flat spot inside the vehicle, near the taillight. Adhere
the black converter box using the provided double-sided tape.
Step 5
When in use, route the 4-flat to the center of the vehicle and out
of the trunk. When not in use, roll up and store in a convenient,
out of the way location inside the trunk. Secure any loose wires
with the provided cable ties.
Step 6
Reinstall all items removed during install. Install the
provided 4-flat dust cover to help prevent corrosion.
INSTALLATION
/
SAFETY INSTRUCTIONS
56038-INS-RA • PAGE 2