Installation Guide

1. Open the rear hatch and remove vehicle
floor coverings and spare tire storage cover.
Remove storage compartment cover on
drivers side by removing two cargo anchor
brackets using a 10 mm socket.
2. Under the storage compartment locate
the vehicles factory tow harness. Insert
the harness into the vehicles tow harness.
Make sure the connectors are fully inserted
with locking tabs in place.
3. Adhere the black converter box to the
frame of the car using the double-sided tape
provided. Secure any loose parts of the
T-connector with the cable ties provided.
4. Route the 4-flat through the grommet in
the rear center of spare tire storage area.
Slit the grommet and seal the grommet with
silicone to make a moisture tight seal.
Outside the vehicle route the 4-flat to the
center of the bumper and secure in a
convienent out of the way location using the
cable ties provided.
WARNING!
Verify miscellaneous items that may be
hidden behind or under any surface before
drilling to avoid damage and/or personal
injury.
3/27/09
56039
MITSUBISHI ENDEAVOR