Installation Guide

INSTALLATION INSTRUCTIONS
WIRING LOCATION GUIDEAPPLICATIONS
NOTICE
WARNING
TOOLS NEEDED
Signal Circuits - 3.0 amps per side
Tail / Running Circuits - 6.0 amps total
Check vehicle owner's manual or contact
the vehicle manufacturer for more information.
10mm socket
Ratchet
Panel trim removal tool
The battery connection must be fuse-protected, 10-amp max.
Exceeding the product rating can cause loss of warranty,
overheating and potential fire. Do not exceed product rating
or tow vehicle lamp load rating, whichever is lower.
WARNING: DO NOT EXCEED PRODUCT RATING OR TOW VEHICLE LAMP LOAD RATING, WHICHEVER IS LOWER
SUVS, MINI & FULL-SIZED VANS
(
S
)
Representative vehicle shown below
S3 - Behind driver side rear access panel
S4 - Behind passenger side rear access panel
S3 S4
All steps must be followed to ensure the wiring connector will
function properly. Once installed, test for proper function by
using a test light or connecting a properly wired trailer.
VEHICLE-TO-TRAILER
CONNECTOR
Make Model
Subaru Ascent
Subaru Forester
Subaru Outback
Subaru Crosstrek (excl Hybrid)
Subaru XV Crosstrek (excl Hybrid)
PAGE 1 • 56040-INS-RD