Installation Guide

INSTALLATION INSTRUCTIONS

CUSTOM WIRING

CONNECTOR

WIRING LOCATION GUIDEAPPLICATIONS

NOTICE

WARNING

TOOLS NEEDED

Check vehicle owner's manual or contact

the vehicle manufacturer for more information.

None

Exceeding the product rating can cause loss of warranty,

overheating and potential fire. Do not exceed product rating

or tow vehicle lamp load rating, whichever is lower.

Make Model

Toyota Highlander with towing prep package

WARNING: DO NOT EXCEED PRODUCT RATING OR TOW VEHICLE LAMP LOAD RATING, WHICHEVER IS LOWER

All steps must be followed to ensure the wiring connector will

function properly. Once installed, test for proper function by

using a test light or connecting a properly wired trailer.

SUVS, MINI & FULL-SIZED VANS

(

)

Representative vehicle shown below

S3 - Behind driver side rear access panel

PAGE 1 • 56042-INS-RA

PAGE 1
INSTALLATION INSTRUCTIONS WARNING: DO NOT EXCEED PRODUCT RATING OR TOW VEHICLE LAMP LOAD RATING, WHICHEVER IS LOWER APPLICATIONS Make Model Toyota Highlander with towing prep package WIRING LOCATION GUIDE SUVS, MINI & FULL-SIZED VANS (S) Representative vehicle shown below S3 - Behind driver side rear access panel CUSTOM WIRING CONNECTOR S3 NOTICE All steps must be followed to ensure the wiring connector will function properly.
PAGE 2
INSTALLATION / SAFETY INSTRUCTIONS Step 1 Open the vehicle tailgate. On the driver side, remove the access panels, threshold, trunk floor panels and trays. Set aside all items removed taking care not to damage parts (A,B,C). Step 2 Starting on the driver side, locate the vehicle 4-pin taillight wiring harness connector. The connectors will be similar to the one on the custom wiring connector. Insert the custom wiring connector into the vehicle connector.