Installation Guide

6. Route the 4-flat wire out from behind the
felt trunk liner to the center of the vehicle.
7. Secure any loose wires with the cable ties
provided.
8. Reinstall all items removed during install.
9. When in use, route the 4-flat out of the
trunk. When not in use, roll up and store in
a convenient out of the way location in the
trunk.
1. Open the trunk and remove the floor
covering (A). Remove the rear scuff panel by
removing two plastic fasteners (B) and
pulling up (C). On both sides of the trunk
pull back on the felt trunk liner to reveal the
vehicle’s taillight wiring harness connectors
(D). The connectors will be similar to those
on the T-Connector harness.
2. On the driver’s side remove the green
and gray connectors from the taillight
housing as shown (E). Take care not to
damage the locking tabs. Insert the
T-Connecter end with the brown wire
between the separated gray connectors.
Insert the T-Connector end with yellow and
red wires between the separated green
connectors.
WARNING!
Verify miscellaneous items that may be
hidden behind or under any surface before
drilling to avoid damage and/or personal
injury.
3. Locate a suitable grounding point near
the connector such as an existing screw with
nut in the vehicle’s frame or drill a 3/32”
hole and secure white ground wire using
ring terminal and screw provided.
4. Adhere the black converter box to the
body panel inside the trunk behind the
vehicle’s felt trunk liner using the
double-sided tape provided.
5. Route the T-Connector end with the
green wire out from behind the felt trunk
liner across to the passenger side behind
the removed rear scuff panel. Repeat Step 2
on the passenger side using the
T-Connector end with the green wire and
green housings.
5/2/2011
56069
VOLVO S40
INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT 1-877-287-8634