Installation Guide

A B C

Step 1

Locate the vehicle taillight wiring connector (A). The connector

plug will be similar to the custom wiring connector plug. Remove

the protective cap from the vehicle plug and set aside (B).

Step 2

Insert the custom wiring connector end into the vehicle

connector. Make sure the connectors are fully inserted with

locking tabs in place (C).

Step 3

When in use, route the 4-flat to the center of the vehicle and out

of the trunk. When not in use, roll up and store in a convenient,

out of the way location inside the trunk. Secure any loose wires

with the provided cable ties (D).

Step 4

Some models may need to be programmed to accept the new

custom wiring connector. This must be done by a dealer.

Step 5

Reinstall all items removed during install. Install the

provided 4-flat dust cover to help prevent corrosion.

INSTALLATION

SAFETY INSTRUCTIONS

56083-INS-RA • PAGE 2