Installation Guide

1. Open the trunk and remove the vehicles rear
scu panel by removing two plastic fasteners.
Pull up on the scu panel to remove being sure
not to damage the allignment tabs. On the
drivers side remove two plastic fasteners and a
screw holding the felt trunk liner in place.
Remove the felt trunk liner to reveal the vehicles
taillight wiring harness. The harness will have
connectors similar to those on the T-connector
harness.
2. Separate the connectors being sure not to
damage the locking tabs. Insert the
T-connector end in-between the separated
connectors make sure the connectors are fully
inserted with locking tabs in place.
3. Locate a suitable grounding point near the
connector such as an existing screw with nut in
the vehicle’s frame or drill a 3/32” hole and
secure white wire using eyelet and screw
provided.
4. Adhere the black converter box to the frame of
the car using the double-sided tape provided.
Secure any loose parts of the T-connector with
the cable ties provided. Reassemble anything
removed during installation.
5. Route the 4-at wire to the center of the
vehicle and out the trunk when in use. When not
in use roll up and store in an out of the way
location in the trunk.
WARNING!
Verify miscellaneous items that may be hidden
behind or under any surface before drilling to
avoid damage and/or personal injury.
9/21/09
56092
CHEVROLET AVEO