Installation Guide

INSTALLATION INSTRUCTIONS

CUSTOM WIRING

CONNECTOR

WIRING LOCATION GUIDEAPPLICATIONS

NOTICE

WARNING

TOOLS NEEDED

Check vehicle owner's manual or contact

the vehicle manufacturer for more information.

Phillips screwdriver

Panel trim removal tool

Exceeding the product rating can cause loss of warranty,

overheating and potential fire. Do not exceed product rating

or tow vehicle lamp load rating, whichever is lower.

Make Model

Cadillac SRX

WARNING: DO NOT EXCEED PRODUCT RATING OR TOW VEHICLE LAMP LOAD RATING, WHICHEVER IS LOWER

SUVS, MINI & FULL-SIZED VANS

(

)

Representative vehicle shown below

S6 - Behind center of rear bumper

All steps must be followed to ensure the wiring connector will

function properly. Once installed, test for proper function by

using a test light or connecting a properly wired trailer.

PAGE 1 • 56096-INS-RA

PAGE 1
INSTALLATION INSTRUCTIONS WARNING: DO NOT EXCEED PRODUCT RATING OR TOW VEHICLE LAMP LOAD RATING, WHICHEVER IS LOWER APPLICATIONS Make Model Cadillac SRX WIRING LOCATION GUIDE SUVS, MINI & FULL-SIZED VANS (S) Representative vehicle shown below S6 - Behind center of rear bumper CUSTOM WIRING CONNECTOR S6 NOTICE All steps must be followed to ensure the wiring connector will function properly. Once installed, test for proper function by using a test light or connecting a properly wired trailer.
PAGE 2
INSTALLATION / SAFETY INSTRUCTIONS Step 1 Remove the two Phillips screws securing the bumper facia (A). Step 2 Behind the facia panel, above the bumper beam, locate the vehicle taillight wiring connectors. The connectors will be similar to those on the custom wiring harness. Remove the white plastic cover from the connector taking care not to damage the locking tabs (B). Step 3 Insert the custom wiring harness end into the vehicle connector.