Installation Guide

A B C

Step 1

Remove the two Phillips screws securing the bumper facia (A).

Step 2

Behind the facia panel, above the bumper beam, locate the

vehicle taillight wiring connectors. The connectors will be

similar to those on the custom wiring harness. Remove the

white plastic cover from the connector taking care not to

damage the locking tabs (B).

Step 3

Insert the custom wiring harness end into the

vehicle connector. Make sure the connectors

are fully inserted with locking tabs in place (C).

Step 4

When in use, route the 4-flat to the center of the vehicle and out

of the trunk. When not in use, roll up and store in a convenient,

out of the way location inside the trunk. Secure any loose wires

with the provided cable ties.

Step 5

Reinstall all items removed during install. Install the

provided 4-flat dust cover to help prevent corrosion.

INSTALLATION

SAFETY INSTRUCTIONS

56096-INS-RA • PAGE 2