Installation Guide

A B C
D E
Step 1
Open the vehicle tailgate. Remove the
two plastic fasteners securing each taillight (A,B).
Step 2
Behind the removed taillights locate the vehicle taillight wiring
harness connectors (C). The connectors will be similar to those
on the custom wiring harness. Separate the connectors from the
taillight housing taking care not to damage the locking tabs.
Step 3
On the driver side insert the custom wiring harness end with
yellow wire between the separated connectors. Make sure the
connectors are fully inserted with locking tabs in place (E).
Step 4
Locate a suitable grounding point near the connector such as
an existing screw with nut in the vehicle frame or drill a 3/32"
pilot hole for the provided screw. The area should be free of
rust, dirt and paint. Secure the white ground wire using the ring
terminal and provided screw.
WARNING: Check for miscellaneous items that may be
hidden behind or under any surface before drilling to avoid
damage and / or personal injury.
Step 5
Route the custom wiring harness end with the green wire
to the passenger side behind the removed scuff panels.
Repeat steps 2-3 on the passenger side using the harness
end with the green wire.
Step 6
When in use, route the 4-flat to the center of the vehicle and out
of the trunk. When not in use, roll up and store in a convenient,
out of the way location inside the trunk. Secure any loose wires
with the provided cable ties.
Step 7
Reinstall all items removed during install. Install the
provided 4-flat dust cover to help prevent corrosion.
INSTALLATION
/
SAFETY INSTRUCTIONS
56109-INS-RA • PAGE 2