Installation Guide

10/22/2010
56124
NISSAN JUKE
1. Open the lift gate (A). Remove the spare tire
cover, foam storage tray, spare tire and the rear
scuff panel (B,C). On the driver and passenger
sides pull out on the rear trim panel to locate the
vehicle’s taillight wiring harnesses (D). The
harnesses will have connectors that are similar to
those on the T-Connector harness.
2. On the driver side separate the connectors
taking care not to damage the locking tabs (E).
Insert the T-Connector end with the yellow wire
between the separated connectors. Make sure
the connectors are fully inserted with locking
tabs in place.
3. Route the T-Connector end with the green wire
across to the passenger side under the removed
rear scuff panel. Repeat Step 2 on the passenger
side using T-Connector end with the green wire.
4. Adhere the black converter box to the frame
of the vehicle using the double-sided tape
provided. Secure any loose parts of the
T-Connector with the cable ties provided.
WARNING!
Verify miscellaneous items that may be hidden
behind or under any surface before drilling to
avoid damage and/or personal injury.
5. Locate a suitable grounding point near the
connector such as an existing screw with nut in
the vehicle’s frame or drill a 3/32” hole and
secure white ground wire using ring terminal and
screw provided.
6. Reinstall all items removed during install.
7. Route the 4-flat wire out from under the rear
trim panel and to the center of the vehicle.
When in use, extend 4-flat from hatch. When not
in use, roll up and store in an out of the way
location in the rear cargo area.
INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT 1-877-287-8634