Installation Guide

12/21/2010
56126
HYUNDAI ELANTRA
1. Open the trunk. Remove the rear scuff
panel by removing three plastic fasteners
holding it in place and pulling up (A).
2. Starting on the driver side remove two
plastic fasteners holding the felt trunk liner in
place. Pull back on the felt trunk liner to
reveal the vehicle’s taillight wiring harness
connectors (C). The harness will have
connectors similar to those on the
T-Connector harness. (NOTE: The connectors
may be wrapped in foam.) Separate the
connectors taking care not to damage the
locking tabs (E). Insert the T-Connector end
with the yellow wire between the separated
connectors. Make sure the connectors are
fully inserted with locking tabs in place.
WARNING!
Verify miscellaneous items that may be hidden
behind or under any surface before drilling to
avoid damage and/or personal injury.
3. Locate a suitable grounding point near the
connector such as an existing screw with nut
in the vehicle’s frame or drill a 3/32” hole and
secure white ground wire using eyelet and
screw provided.
4. Locate a flat spot and adhere the black
converter box to the frame of the vehicle
using the double-sided tape provided.
5. Route the T-Connector end with the green
wire across to the passenger side behind the
rear scuff panel. Repeat Step 2 on the
passenger side using the T-Connector end
with the green wire.
6. Re-install all items removed during install.
INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT 1-877-287-8634