Installation Guide

6/15/2011
56145
CHRYSLER 300C
1. Open the trunk. Remove all trunk floor
covers (A). Remove the rear scuff panel by
pulling out on the bottom and up on the top
(B). On both sides of the trunk remove the
plastic fastener and cargo loop holding the
felt trunk liner in place (C).
2. On the driver’s side pull back on the felt
trunk liner to locate the vehicle’s taillight
wiring harness connectors (D). The
connectors will be similar to those on the
T-Connector harness. Separate the
connectors taking care not to damage the
locking tabs. Insert the T-Connector end
with the yellow wire between the separated
connectors (E). Make sure the connectors
are fully inserted with locking tabs in place.
WARNING!
Verify miscellaneous items that may be
hidden behind or under any surface before
drilling to avoid damage and/or personal
injury.
3. Locate a suitable grounding point near the
connector such as an existing screw with nut
in the vehicle’s frame or drill a 3/32” hole
and secure the eyelet of the white ground
wire using the screw provided.
4. Locate a flat spot and adhere the black
converter box to the frame of the vehicle
using the double-sided tape provided.
5. Route the the T-Connector end with the
green wire to the passenger side behind the
removed scuff panel. Repeat Step 2 on the
passenger side using the T-Connector end
with the green wire. Use the provided cable
ties to secure any loose wires.
6. Route the black power wire to the fuse
panel near the battery. Remove the fuse
panel’s cover and remove the nut securing
the red battery cable(F).
Place the fuse holder’s ring terminal over the
stud and replace the nut. Install the 10 amp
fuse provided in the fuse holder and close
the fuse holder’s cap.
7. Reinstall all items removed during install.
8. Route the 4-flat out from under the felt
trunk liner to the center of the vehicle when
in use. Roll up and store in an out of the way
location when not in use.
INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT 1-877-287-8634