Installation Guide

3/16/2012
56149
HYUNDAI ACCENT
1. Open the trunk. Remove all trunk floor
covers (A). Remove the rear scuff panel by
pulling up on the top (B). On both sides of
the trunk remove the plastic fasteners holding
the felt trunk liner in place (C).
2. On the driver’s side pull back on the felt
trunk liner to locate the vehicle’s taillight
wiring harness connectors (D). The
connectors will be similar to those on the
T-Connector harness. Separate the connectors
taking care not to damage the locking tabs
(E). Insert the T-Connector end with the
yellow wire between the separated
connectors. Make sure the connectors are
fully inserted with locking tabs in place.
WARNING!
Verify miscellaneous items that may be
hidden behind or under any surface before
drilling to avoid damage and/or personal
injury.
3. Locate a suitable grounding point near the
connector such as an existing screw with nut
in the vehicle’s frame or drill a 3/32” hole and
secure the eyelet of the white ground wire
using the screw provided.
4. Locate a flat spot and adhere the black
converter box to the inside body panel of the
vehicle behind the felt trunk liner near the
connector using the double-sided tape
provided.
5. Route the T-Connector end with the green
wire across to the passenger side behind the
removed scuff panel. Repeat Step 2 on the
passenger side using the T-Connector end
with the green wire. Use the cable ties
provided to secure wires to an existing wiring
harness.
6. Route the 4-flat out from under the felt
trunk liner and to the center of the vehicle
and out of the trunk when in use. Roll up and
store in an out of the way location when not
in use.
7. Reinstall all items removed during install.
INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT 1-877-287-8634