Installation Guide

A
Step 1
Locate the vehicle taillight wiring connector behind the rear tire
on the passenger side (A). The vehicle connector will be similar
to the custom wiring connector. Separate the connectors taking
care not to damage the locking tabs.
Step 2
Insert the custom wiring connector end between the separated
vehicle connectors. Make sure the connectors are fully inserted
with locking tabs in place.
Step 3
Locate a suitable grounding point near the connector such as
an existing screw with nut in the vehicle frame or drill a 3/32"
pilot hole for the provided screw. The area should be free of
rust, dirt and paint. Secure the white ground wire using the ring
terminal and provided screw.
WARNING: Check for miscellaneous items that may be
hidden behind or under any surface before drilling to avoid
damage and / or personal injury.
Step 4
When in use, route the 4-flat to the center of the vehicle and out
of the trunk. When not in use, roll up and store in a convenient,
out of the way location inside the trunk. Secure any loose wires
with the provided cable ties.
Step 5
Install the provided 4-flat dust cover to help prevent corrosion.
INSTALLATION
/
SAFETY INSTRUCTIONS
56172-INS-RA • PAGE 2