Installation Guide

A B C
D E F
Step 1
Open the vehicle tailgate (A). Lift up and remove the floor and
cloth roll cover from the plastic floor liner (B). Remove the
plastic floor liner (C).
Step 2
Remove the scuff panel by pulling out on the bottom and then
up. Take care not to damage the alignment tabs on the back
(D). On both sides of the hatch, remove the three Phillips screws
securing the plastic side panels in place. On the passenger side,
remove the inspection cover from the side panel by pulling out.
Step 3
On the driver and passenger sides carefully pull out on the
plastic side wall panels to locate the vehicle taillight wiring
harness connectors (F).
The connectors will be similar to those
on the custom wiring harness. Separate the connectors from the
taillight housing taking care not to damage the locking tabs.
Step 4
Insert the custom wiring harness end with yellow wire between
the separated connectors. Make sure the connectors are fully
inserted with locking tabs in place.
Step 5
Locate a suitable grounding point near the connector such as
an existing screw with nut in the vehicle frame or drill a 3/32"
pilot hole for the provided screw. The area should be free of
rust, dirt and paint. Secure the white ground wire using the ring
terminal and provided screw.
WARNING: Check for miscellaneous items that may be
hidden behind or under any surface before drilling to avoid
damage and / or personal injury.
Step 6
Locate a flat clean surface that is out of the path of spray
and debris from the rear wheels and road. Adhere the black
converter box using the provided double-sided tape. Failure to
mount the box in a protected area can cause loss of warranty,
product failure, overheating and potential fire.
Step 7
Route the custom wiring harness end with the green wire
to the passenger side behind the removed scuff panels.
Repeat steps 3-4 on the passenger side using the harness
end with the green wire.
Step 8
Route the black power wire from the vehicle battery
as shown on the included CME-PCL-INS sheet.
Step 9
When in use, route the 4-flat to the center of the vehicle and out
of the trunk. When not in use, roll up and store in a convenient,
out of the way location inside the trunk. Secure any loose wires
with the provided cable ties.
Step 10
Reinstall all items removed during install. Install the
provided 4-flat dust cover to help prevent corrosion.
INSTALLATION
/
SAFETY INSTRUCTIONS
56189-INS-RA • PAGE 2