Installation Guide

ManualsBrandsCURT ManualsOtherCustom Vehicle-Trailer Wiring Harness, 4-Way Flat Output, Select Ford Fiesta Hatchback, Quick T-Connector

7/30/2013

56191

FORD FIESTA HATCHBACK

1. Open the rear hatch and remove all ﬂoor

coverings (A). Remove the two Torx T-30

head screws securing the rear scuff panel

and then remove the scuff panel by pulling

out on the bottom and then up (B,C).

2. On both sides of the hatch remove the

phillips drive screw in the trim (D). Pull out

on the trim to release the trunk liner. On

both sides of the trunk, pull out on the trunk

liner to access the tallights’ wiring harness so

the T-Connector can can be installed (E).

3. On the driver’s side, locate the vehicle’s

taillight wiring harness connectors. The

connectors will be similar to those on the

T-Connector harness. Separate the

connectors taking care not to damage the

locking tabs. Insert the T-Connector end

with the yellow wire between the separated

connectors (F). Make sure the connectors

are fully inserted with locking tabs in place.

WARNING!

Verify miscellaneous items that may be

hidden behind or under any surface before

drilling to avoid damage and/or personal

injury.

4. Locate a suitable grounding point near the

connector such as an existing screw with nut

in the vehicle’s frame or drill a 3/32” hole

and secure the eyelet of the white ground

wire using the screw provided.

5. Locate a ﬂat spot and adhere the black

converter box to the frame of the vehicle

using the double-sided tape provided.

6. Route the T-Connector end with the green

wire to the passenger side behind the trunk

liner and removed scuff panel. Repeat Step 2

on the passenger side using the T-Connector

end with the green wire. Use the provided

cable ties to secure any loose wires.

7. Reinstall all items removed during install.

8. Route the 4-ﬂat out from under the felt

trunk liner to the center of the vehicle when in

use. Roll up and store in an out of the way

location when not in use.

IMPORTANT:

Exceeding the product’s load rating can cause

loss of warranty, overheating and potentially

ﬁre. Do not exceed the tow vehicle’s lamp

load rating or the product rating, whichever is

lower:

Signal Circuits: 3.0 Amps

Tail/Running Light Circuits: 7.5 Amps

Check the vehicle owner’s manual or contact

the vehicle’s manufacturer for more

information.

INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT 1-877-287-8634

Summary of content (2 pages)

PAGE 1
56191 FORD FIESTA HATCHBACK 1. Open the rear hatch and remove all ﬂoor coverings (A). Remove the two Torx T-30 head screws securing the rear scuff panel and then remove the scuff panel by pulling out on the bottom and then up (B,C). 2. On both sides of the hatch remove the phillips drive screw in the trim (D). Pull out on the trim to release the trunk liner. On both sides of the trunk, pull out on the trunk liner to access the tallights’ wiring harness so the T-Connector can can be installed (E). 3.
PAGE 2