Installation Guide

Step 1
Open the hatch and lift up on the storage lid (A,B). Locate
the access panel on the driver's side rear trim panel (C).
Step 2
Remove the access panel to locate
the vehicle's electrical junction box (D).
Step 3
Starting in the cargo area on the driver's side, route the
white housing end of the harness under the trim panel up
to the junction box. Insert the white housing of the wiring
harness into the receptacle in the junction box (E).
Step 4
In the electrical junction box, locate the two fuse placements.
Insert the 10 amp low profile fuse in position 2 and the 7.5 amp
low profile fuse in position 11 (E).
Step 5
Locate a suitable grounding point near the connector such as
an existing screw with nut in the vehicle frame or drill a 3/32"
pilot hole for the provided screw. The area should be free of
rust, dirt and paint. Secure the white ground wire using the ring
terminal and provided screw. (F)
WARNING: Check for miscellaneous items that may be
hidden behind or under any surface before drilling to avoid
damage and / or personal injury.
Step 6
Locate a flat spot inside the vehicle. Adhere the black
converter box using the provided double-sided tape (G).
Step 7
When in use, route the 4-flat to the center of the vehicle. When
not in use, roll up and store in a convenient, out of the way
location (H). Secure any loose wires with the provided cable ties.
Step 8
Install the 10 amp fuse that is provided into the red
fuse holder located on the product wiring harness.
Step 9
Reinstall all items removed during install. Install the
provided 4-flat dust cover to help prevent corrosion.
INSTALLATION
/
SAFETY INSTRUCTIONS
A B
H
C
D
G
E
10 AMP
7.5 AM P
F
56192-INS-RB • PAGE 2