Installation Guide

INSTALLATION INSTRUCTIONS

CUSTOM WIRING HARNESS

WIRING LOCATION GUIDEAPPLICATIONS

NOTICE

WARNING

TOOLS NEEDED

Signal Circuits - 3.0 amps per side

Tail / Running Circuits - 6.0 amps total

Check vehicle owner's manual or contact

the vehicle manufacturer for more information.

Phillips screwdriver

T-15 Torx bit

T-27 Torx bit

Make Model

Jeep Cherokee

WARNING: DO NOT EXCEED PRODUCT RATING OR TOW VEHICLE LAMP LOAD RATING, WHICHEVER IS LOWER

SUVS, MINI & FULL-SIZED VANS

(

)

Representative vehicle shown below

S1 - Behind driver side taillight housing

S2 - Behind passenger side taillight housing

S1 S2

All steps must be followed to ensure the wiring harness

will function properly. Once installed, test for proper function

by using a test light or connecting a properly wired trailer.

The battery connection must be fuse-protected, 10-amp max.

Exceeding the product rating can cause loss of warranty,

overheating and potential fire. Do not exceed product rating

or tow vehicle lamp load rating, whichever is lower.

PAGE 1 • 56208-INS-RA

PAGE 1
INSTALLATION INSTRUCTIONS WARNING: DO NOT EXCEED PRODUCT RATING OR TOW VEHICLE LAMP LOAD RATING, WHICHEVER IS LOWER APPLICATIONS Make Model Jeep Cherokee WIRING LOCATION GUIDE SUVS, MINI & FULL-SIZED VANS (S) Representative vehicle shown below S1 - Behind driver side taillight housing S2 - Behind passenger side taillight housing CUSTOM WIRING HARNESS S1 S2 NOTICE All steps must be followed to ensure the wiring harness will function properly.
PAGE 2
INSTALLATION / SAFETY INSTRUCTIONS Step 1 Open the vehicle tailgate. Remove the two cargo-tie down fasteners on each side of the vehicle. Remove the storage holder on the driver side (A). Lift the trunk floor cover and remove all items under it. Locate and remove the two Phillips screws securing the spare tire surround (B,C). Step 6 Locate a suitable grounding point near the connector such as an existing screw with nut in the vehicle frame or drill a 3/32" pilot hole for the provided screw.