Installation Guide

INSTALLATION INSTRUCTIONS

CUSTOM WIRING HARNESS

WIRING LOCATION GUIDEAPPLICATIONS

NOTICE

WARNING

TOOLS NEEDED

Signal Circuits - 7.5 amps per side

Tail / Running Circuits - 7.5 amps total

Check vehicle owner's manual or contact

the vehicle manufacturer for more information.

Flat blade screwdriver

Phillips screwdriver

Make Model

Ram ProMaster

WARNING: DO NOT EXCEED PRODUCT RATING OR TOW VEHICLE LAMP LOAD RATING, WHICHEVER IS LOWER

SUVS, MINI & FULL-SIZED VANS

(

)

Representative vehicle shown below

S3 - Behind driver side rear access panel

S4 - Behind passenger side rear access panel

S3 S4

All steps must be followed to ensure the wiring harness

will function properly. Once installed, test for proper function

by using a test light or connecting a properly wired trailer.

The battery connection must be fuse-protected, 10-amp max.

Exceeding the product rating can cause loss of warranty,

overheating and potential fire. Do not exceed product rating

or tow vehicle lamp load rating, whichever is lower.

PAGE 1 • 56209-INS-RA

PAGE 1
INSTALLATION INSTRUCTIONS WARNING: DO NOT EXCEED PRODUCT RATING OR TOW VEHICLE LAMP LOAD RATING, WHICHEVER IS LOWER APPLICATIONS Make Model Ram ProMaster WIRING LOCATION GUIDE SUVS, MINI & FULL-SIZED VANS (S) Representative vehicle shown below S3 - Behind driver side rear access panel S4 - Behind passenger side rear access panel CUSTOM WIRING HARNESS S3 S4 NOTICE All steps must be followed to ensure the wiring harness will function properly.
PAGE 2
INSTALLATION / SAFETY INSTRUCTIONS Step 1 Locate the vehicle battery under the driver side floor panel. Turn the six fasteners securing the floor panel and remove the panel to disconnect the negative battery terminal (A,B). Step 2 Open the rear cargo doors. Starting on the driver side, remove the seven Phillips screws from the plastic cover to locate the vehicle taillight wiring harness connectors (C). The connectors will be similar to those on the custom wiring harness.
PAGE 3
INSTALLATION / SAFETY INSTRUCTIONS Step 7 Starting on the back side of the driver seat, remove the Phillips screws from the plastic seat belt trim panel (H) and the trim around the driver side seat and floor. Remove all the plastic trim panels (H,I,J,K,L). Step 9 When in use, route the 4-flat to the center of the vehicle and out of the cargo area. When not in use, roll up and store in a convenient, out of the way location inside the trunk. Secure any loose wires with the provided cable ties.