Installation Guide

A B C

E F

Step 1

Locate the vehicle battery under the driver side floor panel. Turn

the six fasteners securing the floor panel and remove the panel

to disconnect the negative battery terminal (A,B).

Step 2

Open the rear cargo doors. Starting on the driver side, remove

the seven Phillips screws from the plastic cover to locate the

vehicle taillight wiring harness connectors (C). The connectors

will be similar to those on the custom wiring harness. Separate

the connectors from the taillight housing taking care not to

damage the locking tabs (D).

Step 3

Insert the custom wiring harness end with yellow wire between

the separated connectors. Make sure the connectors are fully

inserted with locking tabs in place (E).

Step 4

Locate a suitable grounding point near the connector such as

an existing screw with nut in the vehicle frame or drill a 3/32"

pilot hole for the provided screw. The area should be free of

rust, dirt and paint. Secure the white ground wire using the ring

terminal and provided screw.

WARNING: Check for miscellaneous items that may be

hidden behind or under any surface before drilling to avoid

damage and / or personal injury.

Step 5

Route the custom wiring harness end with the green wire

to the passenger side through the opening that runs up and

over the rear cargo doors. Repeat steps 2-3 on the passenger

side using the harness end with the green wire (F).

Step 6

Inside the vehicle on the driver side, locate a flat spot on the

upper corner inside the rear cargo door frame to adhere the

black converter box using the provided double-sided tape (G).

INSTALLATION

SAFETY INSTRUCTIONS

56209-INS-RA • PAGE 2