Installation Guide

INSTALLATION INSTRUCTIONS

CUSTOM WIRING

CONNECTOR

WIRING LOCATION GUIDEAPPLICATIONS

NOTICE

WARNING

TOOLS NEEDED

Check vehicle owner's manual or contact

the vehicle manufacturer for more information.

3/16" allen wrench

Make Model

Chevrolet Equinox with tow package

GMC Terrain with tow package

WARNING: DO NOT EXCEED PRODUCT RATING OR TOW VEHICLE LAMP LOAD RATING, WHICHEVER IS LOWER

SUVS, MINI & FULL-SIZED VANS

(

)

Representative vehicle shown below

S3 - Behind driver side rear access panel

All steps must be followed to ensure the wiring connector will

function properly. Once installed, test for proper function by

using a test light or connecting a properly wired trailer.

Exceeding the product rating can cause loss of warranty,

overheating and potential fire. Do not exceed product rating

or tow vehicle lamp load rating, whichever is lower.

PAGE 1 • 56210-INS-RA

PAGE 1
INSTALLATION INSTRUCTIONS WARNING: DO NOT EXCEED PRODUCT RATING OR TOW VEHICLE LAMP LOAD RATING, WHICHEVER IS LOWER APPLICATIONS WIRING LOCATION GUIDE SUVS, MINI & FULL-SIZED VANS (S) Make Model Chevrolet Equinox with tow package Representative vehicle shown below GMC Terrain with tow package S3 - Behind driver side rear access panel CUSTOM WIRING CONNECTOR S3 NOTICE All steps must be followed to ensure the wiring connector will function properly.
PAGE 2
INSTALLATION / SAFETY INSTRUCTIONS Step 1 Open the vehicle trunk. Remove all trunk floor coverings (A). Remove the two cargo fasteners on the driver side. Remove the rear scuff panel by pulling out on the bottom and then up. Take care not to damage the alignment tabs on the back. (B). Step 2 On the driver side only, partially remove the lower trim panel to locate the vehicle taillight wiring connectors. Carefully pull outwards on the lower trim panel (C).