Installation Guide

A B
H
C
D
G
I
E F
Step 1
Locate vehicle battery on the driver side under the hood
and disconnect the negative battery terminal.
Step 2
Open the rear cargo doors (A). Remove the scuff panel by
pulling out on the bottom and then up. Take care not to damage
the alignment tabs on the back (B).
Step 3
Starting on the driver side, remove the plastic access cover
to locate the vehicle taillight wiring harness connectors (C).
The connectors will be similar to those on the custom wiring
harness. Separate the connectors from the taillight housing
taking care not to damage the locking tabs (D).
Step 4
Insert the custom wiring harness end with yellow wire between
the separated connectors. Make sure the connectors are fully
inserted with locking tabs in place (E).
Step 5
Locate a suitable grounding point near the connector such as
an existing screw with nut in the vehicle frame or drill a 3/32"
pilot hole for the provided screw. The area should be free of
rust, dirt and paint. Secure the white ground wire using the ring
terminal and provided screw.
WARNING: Check for miscellaneous items that may be
hidden behind or under any surface before drilling to avoid
damage and / or personal injury.
Step 6
Locate a flat spot inside the vehicle, near the taillight. Adhere
the black converter box using the provided double-sided tape (F).
Step 7
Route the custom wiring harness end with the green wire to
the passenger side behind the removed scuff panel. Repeat
steps 3-4 on the passenger side using the harness end with
the green wire (G, H, I).
Step 8
Route the black power wire from the vehicle battery
as shown on the included CME-PCL-INS sheet.
Step 9
When in use, route the 4-flat to the center of the vehicle and out
of the trunk. When not in use, roll up and store in a convenient,
out of the way location inside the trunk. Secure any loose wires
with the provided cable ties.
Step 10
Reinstall all items removed during install and reconnect
negative battery terminal. Install the provided 4-flat dust
cover to help prevent corrosion.
INSTALLATION
/
SAFETY INSTRUCTIONS
56218-INS-RA • PAGE 2