Installation Guide

A B
H
C
D
G
E F
Step 1
Locate vehicle battery on the driver side under the
hood and disconnect the negative battery terminal (A).
Step 2
Open the vehicle's trunk. Remove all trunk floor coverings (B,C).
Step 3
Remove the three push fasteners securing the scuff panel (D).
Remove the scuff panel by pulling up. Be sure not to damage
the alignment tabs located on the back side (E).
Step 4
Starting on the driver side, remove the push fasteners and
cargo fastener from the felt trunk liner (F).
Step 5
Pull back on the felt liner to locate the vehicle taillight wiring
harness connectors. The connectors will be similar to those
on the T-connector harness. Separate the connectors from the
taillight housing taking care not to damage the locking tabs (G).
Step 6
Insert the T-connector end with yellow wire between
the separated connectors. Make sure the connectors
are fully inserted with locking tabs in place (H).
WARNING: Check for miscellaneous items that
may be hidden behind or under any surface before
drilling to avoid damage and / or personal injury.
Step 7
Locate a suitable grounding point near the connector such as
an existing screw with nut in the vehicle frame or drill a 3/32"
pilot hole for the provided screw. The area should be free of
rust, dirt and paint. Secure the white ground wire using the
ring terminal and provided screw.
Step 8
Route the T-connector end with the green wire to the passenger
side behind the removed scuff panels. Repeat Steps 4-6 on the
passenger side using the T-connector end with the green wire.
Step 9
Locate a flat spot inside the vehicle, near the taillight. Adhere
the black converter box using the provided double-sided tape (H).
Step 10
Route the black power wire from the vehicle battery
as shown on the included CME-PCL-INS sheet.
Step 11
When in use, route the 4-flat to the center of the vehicle and out
of the trunk. When not in use, roll up and store in a convenient,
out of the way location inside the trunk. Secure any loose wires
with the provided cable ties.
Step 12
Reinstall all items removed during install and reconnect the
negative battery terminal. Install the provided 4-flat dust cover
to help prevent corrosion.
INSTALLATION
/
SAFETY INSTRUCTIONS
56246-INS-RB • PAGE 2