Owners manual

INSTALLATION INSTRUCTIONS

CUSTOM WIRING HARNESS

WIRING LOCATION GUIDEAPPLICATIONS

NOTICE

WARNING

TOOLS NEEDED

Signal Circuits - 3.0 amps per side

Tail / Running Circuits - 6.0 amps total

Check vehicle owner's manual or contact

the vehicle manufacturer for more information.

10mm socket

Ratchet

Panel trim removal tool

Wire stripper

Wire crimper

Cutting tool

The battery connection must be fuse-protected, 10-amp max.

Exceeding the product rating can cause loss of warranty,

overheating and potential fire. Do not exceed product rating

or tow vehicle lamp load rating, whichever is lower.

Make Model

Toyota Prius C

WARNING: DO NOT EXCEED PRODUCT RATING OR TOW VEHICLE LAMP LOAD RATING, WHICHEVER IS LOWER

PASSENGER CARS

(

)

Representative vehicle shown below

P3 - Behind driver side taillight housing, inside of trunk

P4 - Behind passenger side taillight housing, inside of trunk

P3 P4

All steps must be followed to ensure the wiring harness

will function properly. Once installed, test for proper function

by using a test light or connecting a properly wired trailer.

PAGE 1 • 56275-INS-RB

PAGE 1
INSTALLATION INSTRUCTIONS WARNING: DO NOT EXCEED PRODUCT RATING OR TOW VEHICLE LAMP LOAD RATING, WHICHEVER IS LOWER APPLICATIONS Make Model Toyota Prius C WIRING LOCATION GUIDE PASSENGER CARS (P) Representative vehicle shown below P3 - Behind driver side taillight housing, inside of trunk P4 - Behind passenger side taillight housing, inside of trunk CUSTOM WIRING HARNESS P3 P4 NOTICE All steps must be followed to ensure the wiring harness will function properly.
PAGE 2
INSTALLATION / SAFETY INSTRUCTIONS Step 1 Locate the vehicle battery by removing the push fasteners on the trim panel below the passenger rear seat (A). Press center of the retainer inward to release fastener. Disengage the three clips and guides on the back of the cover to remove the 12-volt battery cover. Disconnect the negative battery terminal (B). Step 2 Open the vehicle trunk. Remove all trunk floor coverings (C). Step 3 Remove the two fasteners securing the scuff panel.