Installation Guide

INSTALLATION INSTRUCTIONS

CUSTOM WIRING HARNESS

WIRING LOCATION GUIDEAPPLICATIONS

NOTICE

WARNING

TOOLS NEEDED

Signal Circuits - 3.0 amps per side

Tail / Running Circuits - 6.0 amps total

Check vehicle owner's manual or contact

the vehicle manufacturer for more information.

10mm socket

Ratchet

T-15 Torx bit

Phillips screwdriver

Flat blade screwdriver

Make Model

Dodge Nitro

Jeep Liberty

WARNING: DO NOT EXCEED PRODUCT RATING OR TOW VEHICLE LAMP LOAD RATING, WHICHEVER IS LOWER

SUVS, MINI & FULL-SIZED VANS

(

)

Representative vehicle shown below

S1 - Behind driver side taillight housing

S2 - Behind passenger side taillight housing

S1 S2

All steps must be followed to ensure the wiring harness

will function properly. Once installed, test for proper function

by using a test light or connecting a properly wired trailer.

The battery connection must be fuse protected, 10 amp max.

Exceeding the product rating can cause loss of warranty,

overheating and potential fire. Do not exceed product rating

or tow vehicle lamp load rating, whichever is lower.

PAGE 1 • 56334-INS-RA

PAGE 1
INSTALLATION INSTRUCTIONS WARNING: DO NOT EXCEED PRODUCT RATING OR TOW VEHICLE LAMP LOAD RATING, WHICHEVER IS LOWER APPLICATIONS WIRING LOCATION GUIDE SUVS, MINI & FULL-SIZED VANS (S) Make Model Dodge Nitro Representative vehicle shown below Jeep Liberty S1 - Behind driver side taillight housing S2 - Behind passenger side taillight housing CUSTOM WIRING HARNESS S1 S2 NOTICE All steps must be followed to ensure the wiring harness will function properly.
PAGE 2
INSTALLATION / SAFETY INSTRUCTIONS Step 1 Locate vehicle battery on the driver side under the hood and disconnect the negative battery terminal. Step 2 Open the vehicle tailgate. Remove the two bolts holding each taillight assembly in place (A). Remove both taillights taking care not to damage the alignment tabs. Step 3 Starting on the driver side, locate the vehicle taillight wiring harness connectors. The connectors will be similar to those on the custom wiring harness.