Installation Guide

INSTALLATION INSTRUCTIONS

CUSTOM WIRING

CONNECTOR

WIRING LOCATION GUIDEAPPLICATIONS

NOTICE

WARNING

TOOLS NEEDED

Signal Circuits - 3.0 amps per side

Tail / Running Circuits - 6.0 amps total

Check vehicle owner's manual or contact

the vehicle manufacturer for more information.

Ratchet

10mm socket

Panel trim removal tool

The battery connection must be fuse-protected, 10-amp max.

Exceeding the product rating can cause loss of warranty,

overheating and potential fire. Do not exceed product rating

or tow vehicle lamp load rating, whichever is lower.

Make Model

Mazda CX-9

WARNING: DO NOT EXCEED PRODUCT RATING OR TOW VEHICLE LAMP LOAD RATING, WHICHEVER IS LOWER

All steps must be followed to ensure the wiring connector will

function properly. Once installed, test for proper function by

using a test light or connecting a properly wired trailer.

All connections must be complete for the harness to function

properly. Test and verify the installation of the product with a

test light or trailer after installation is complete. For the initial

test, reset the electrical system of the vehicle by temporarily

removing the vehicle key from the ignition.

SUVS, MINI & FULL-SIZED VANS

(

)

Representative vehicle shown below

S4 - Behind passenger side rear access panel

PAGE 1 • 56338-INS-RA

PAGE 1
INSTALLATION INSTRUCTIONS WARNING: DO NOT EXCEED PRODUCT RATING OR TOW VEHICLE LAMP LOAD RATING, WHICHEVER IS LOWER APPLICATIONS Make Model Mazda CX-9 WIRING LOCATION GUIDE SUVS, MINI & FULL-SIZED VANS (S) Representative vehicle shown below S4 - Behind passenger side rear access panel CUSTOM WIRING CONNECTOR S4 NOTICE All steps must be followed to ensure the wiring connector will function properly.
PAGE 2
INSTALLATION / SAFETY INSTRUCTIONS Step 1 Locate vehicle battery on the driver side under the hood and disconnect the negative battery terminal. Step 2 Open the rear hatch and remove the floor coverings and storage trays on the passenger side (A,B). Step 3 Remove the scuff panel by using a pry tool. Take care not to damage the alignment tabs on the back (C). Step 4 Unscrew and remove the tire jack. Remove the cargo loops from the rear trim panel using a 10mm socket (D).