Installation Guide

A B C
D E F
Step 1
Locate vehicle battery on the driver side under the
hood and disconnect the negative battery terminal (A).
Step 2
Open the vehicle tailgate to gain access to the taillight assembly.
Step 3
Starting on the driver side, remove the two fasteners securing
the taillight assembly (B). Loosen the taillight by gently pulling
rearward and out.
Step 4
Behind the taillight, locate the vehicle taillight wiring harness
connectors (C). The connectors will be similar to those on
the custom wiring harness. Separate the connectors from the
taillight housing taking care not to damage the locking tabs (D).
Set the taillight aside.
Step 5
Using a section of wire, route the custom wiring harness end
with the yellow wire from underneath the vehicle through the
opening under the taillight (E).
Insert the wiring harness end with yellow wire between the
separated connectors. Make sure the connectors are fully
inserted with locking tabs in place (F).
Step 6
Locate a suitable grounding point near the connector such as
an existing screw with nut in the vehicle frame or drill a 3/32"
pilot hole for the provided screw. The area should be free of
rust, dirt and paint. Secure the white ground wire using the
ring terminal and provided screw.
WARNING: Check for miscellaneous items that
may be hidden behind or under any surface before
drilling to avoid damage and / or personal injury.
Step 7
Locate a flat clean surface that is out of the path of spray
and debris from the rear wheels and road. Adhere the black
converter box using the provided double-sided tape. Failure to
mount the box in a protected area can cause loss of warranty,
product failure, overheating and potential fire.
Step 8
Route the black power wire from the vehicle battery
as shown on the included CME-PCL-INS sheet.
Step 9
Route the custom wiring harness end with the green wire
along the backside of the bumper to the passenger side and
up through the opening under the taillight. Repeat steps 3-5 on
the passenger side using the harness end with the green wire.
Step 10
When in use, route the 4-flat to the center of the vehicle. When
not in use, roll up and store in a convenient, out of the way
location. Secure any loose wires with the provided cable ties.
Step 11
Reinstall all items removed during install and reconnect
negative battery terminal. Install the provided 4-flat dust cover
to help prevent corrosion.
INSTALLATION
/
SAFETY INSTRUCTIONS
56348-INS-RA • PAGE 2