Installation Guide

A B C
D E
Step 1
Locate vehicle battery on the driver side under the
hood and disconnect the negative battery terminal.
Step 2
Open the vehicle tailgate. Remove the 10mm screws securing
the taillight in place (A). Remove the taillight by carefully prying
on the outer edge of the light. Take care not to damage the
alignment tabs.
Step 3
Starting on the driver side, locate the vehicle taillight wiring
harness connectors. The connectors will be similar to those on
the custom wiring harness (B). Separate the connectors from the
taillight housing taking care not to damage the locking tabs (C).
Step 4
Insert the custom wiring harness end with yellow, brown and
red wires between the separated connectors. Make sure the
connectors are fully inserted with locking tabs in place.
Step 5
Locate a suitable grounding point near the connector such as
an existing screw with nut in the vehicle frame or drill a 3/32"
pilot hole for the provided screw. The area should be free of
rust, dirt and paint. Secure the white ground wire using the ring
terminal and provided screw.
WARNING: Check for miscellaneous items that may
be hidden behind or under any surface before drilling to avoid
damage and / or personal injury.
Step 6
Route the custom wiring harness end with the green wire out
through the hole between the vehicle bumper and body, to the
passenger side, and up through the hole. Insert the housings
into the vehicle connectors (D).
Step 7
Locate a flat clean surface that is out of the path of spray
and debris from the rear wheels and road. Adhere the black
converter box using the provided double-sided tape. Failure to
mount the box in a protected area can cause loss of warranty,
product failure, overheating and potential fire (E).
Step 8
Route the black power wire from the vehicle battery
as shown on the included CME-PCL-INS sheet.
Step 9
When in use, route the 4-flat to the center of the vehicle. When
not in use, roll up and store in a convenient, out of the way
location. Secure any loose wires with the provided cable ties.
Step 10
Reinstall all items removed during install and reconnect
negative battery terminal. Install the provided 4-flat dust
cover to help prevent corrosion.
INSTALLATION
/
SAFETY INSTRUCTIONS
56349-INS-RA • PAGE 2