Installation Guide

INSTALLATION INSTRUCTIONS

CUSTOM WIRING

CONNECTOR

WIRING LOCATION GUIDEAPPLICATIONS

NOTICE

WARNING

TOOLS NEEDED

Stop / Turn Light - 10.0 amps total

Taillights - 10.0 amps total

Backup - 10.0 amps total

Trailer Brakes - 3 Axles / 6 Brakes, 20.0 amps total

Check vehicle owner's manual or contact

the vehicle manufacturer for more information.

10mm socket

Ratchet

Panel trim removal tool

Phillips screwdriver

Wire stripper

Cutting tool

Exceeding the product rating can cause loss of warranty,

overheating and potential fire. Do not exceed product rating

or tow vehicle lamp load rating, whichever is lower.

Make Model

Inﬁniti QX60

Nissan Pathﬁnder

WARNING: DO NOT EXCEED PRODUCT RATING OR TOW VEHICLE LAMP LOAD RATING, WHICHEVER IS LOWER

SUVS, MINI & FULL-SIZED VANS

(

)

Representative vehicle shown below

S3 - Behind driver side rear access panel

S5 - Behind driver side rear bumper

All steps must be followed to ensure the wiring connector will

function properly. Once installed, test for proper function by

using a test light or connecting a properly wired trailer.

PAGE 1 • 56357-INS-RA

PAGE 1
INSTALLATION INSTRUCTIONS WARNING: DO NOT EXCEED PRODUCT RATING OR TOW VEHICLE LAMP LOAD RATING, WHICHEVER IS LOWER APPLICATIONS WIRING LOCATION GUIDE SUVS, MINI & FULL-SIZED VANS (S) Make Model Infiniti QX60 Representative vehicle shown below Nissan Pathfinder S3 - Behind driver side rear access panel S5 - Behind driver side rear bumper CUSTOM WIRING CONNECTOR S3 S5 NOTICE All steps must be followed to ensure the wiring connector will function properly.
PAGE 2
INSTALLATION / SAFETY INSTRUCTIONS Step 1 Locate vehicle battery on the driver side under the hood and disconnect the negative battery terminal. Step 2 Open the vehicle trunk. Fold down the rear seats and remove the floor push fasteners that attach to the rear seats (A). Step 3 Lift up on the floor cargo storage lid to locate the three 10mm bolts securing the cargo storage unit in place (B).
PAGE 3
INSTALLATION / SAFETY INSTRUCTIONS (CONTINUED) Step 8 On the driver side, under the side trim panel, locate the vehicle wiring connectors (J). The connectors will be similar to those on the custom wiring connector. Step 11 Insert the custom wiring connector into the vehicle wiring connector. Make sure the connectors are fully inserted with locking tabs in place. Step 9 Insert the custom wiring connector into the vehicle wiring connector.