Installation Guide

ManualsBrandsCURT ManualsAutomotiveCustom Vehicle-Trailer Wiring Harness, 4-Way Flat Output, Select Volkswagen Golf Alltrack, Quick Wire T-Connector

56391-INS-RB

•

PAGE 1

INSTALLATION MANUAL

Tools Required

Panel trim

removal tool

Wire crimper

Wire stripper Cutting tool

Wiring Location(s)

S3 and S4

WARNING

Do not exceed product rating or tow vehicle lamp load rating, whichever is lower.

The battery connection must be fuse-protected, 15-amp max. Exceeding

the product rating can cause loss of warranty, overheating and potential fire.

Product Registration and Warranty

CURT Group stands behind our products with industry-leading warranties.

Provide feedback and help us to improve our products by registering your purchase at:

warranty.curtgroup.com/surveys

Maintenance

Periodic inspection of all wires and connections should be performed

to ensure there is no visible damage or loose connections.

Electrical Ratings

Signal circuits 5.0-amps per side

Tail / Running Circuits 7.5-amps total

Check vehicle owner's manual or contact

the vehicle manufacturer for more information.

Wiring Location Guide*

for SUVs and Vans (S)

S1 Behind driver side taillight housing

S2 Behind passenger side taillight housing

S3 Behind driver side rear access panel

Behind passenger side rear access panel

S5 Behind driver side rear bumper

S6 Behind center of rear bumper

S7 Behind passenger side rear bumper

S8 Under rear floor panel

S5 S6 S7

* Representative vehicle shown

NOTICE

Before you begin installation, read all instructions thoroughly.

Proper tools will improve the quality of installation and reduce the time required.

All steps must be followed to ensure the product will function properly. Once installed,

test for proper function by using a test light or connecting a properly wired trailer.

Product Photo

Hardware Photo

Level of Difﬁculty

Moderate

Summary of content (4 pages)

PAGE 1
INSTALLATION MANUAL WARNING Level of Difficulty Do not exceed product rating or tow vehicle lamp load rating, whichever is lower. The battery connection must be fuse-protected, 15-amp max. Exceeding the product rating can cause loss of warranty, overheating and potential fire. Moderate Electrical Ratings Signal circuits Tail / Running Circuits 5.0-amps per side 7.5-amps total Product Photo Check vehicle owner's manual or contact the vehicle manufacturer for more information.
PAGE 2
Step 1 Locate the vehicle battery. Look up the battery location in the owner's manual of your vehicle. Disconnect the negative battery terminal. Be sure to fasten this wire down and away from the battery when completing the installation process. Step 2 Open the vehicle trunk. Remove the trunk floor coverings. Step 3 Remove the scuff panel by pulling out on the bottom and then up. Take care not to damage the alignment tabs on the back.
PAGE 3
Step 6 Pull back on the felt side liner to locate the vehicle taillight wiring harness connectors. The connectors will be similar to those on the custom wiring harness. Separate the connectors from the taillight housing by pulling back on the red locking tab and pressing down on the top side tab. Take care not to damage the locking tabs. Insert the custom wiring harness end with yellow wire between the separated connectors. Make sure the connectors are fully inserted with locking tabs in place.
PAGE 4
POWERED CONVERTER LEAD INSTRUCTION SHEET FICHE DE CONSIGNES DU CONVERTISSEUR D'ALIMENTATION HOJA DE INSTRUCCIONES DEL CONDUCTOR DEL ADAPTADOR ALIMENTADO POR BATERÍA NOTICE AVIS / AVISO WARNING AVERTISSEMENT / ADVERTENCIA Illustrations are for reference only. Battery location may differ depending on the vehicle. To avoid personal injury or property damage, check for miscellaneous items that may be behind or under any surface before drilling. Les images ne sont fournies qu'à des fins de référence.