Installation Guide

INSTALLATION INSTRUCTIONS

CUSTOM WIRING

CONNECTOR

WIRING LOCATION GUIDEAPPLICATIONS

NOTICE

WARNING

TOOLS NEEDED

Signal Circuits - 7.5 amps per side

Tail / Running Circuits - 7.5 amps total

Check vehicle owner's manual or contact

the vehicle manufacturer for more information.

Ratchet

15mm socket

Socket extension

Flat blade screwdriver

Panel trim removal tool

Cutting tool

Exceeding the product rating can cause loss of warranty,

overheating and potential fire. Do not exceed product rating

or tow vehicle lamp load rating, whichever is lower.

Make Model

Chevrolet Trav e rse

WARNING: DO NOT EXCEED PRODUCT RATING OR TOW VEHICLE LAMP LOAD RATING, WHICHEVER IS LOWER

SUVS, MINI & FULL-SIZED VANS

(

)

Representative vehicle shown below

S5 - Behind driver side rear bumper

All steps must be followed to ensure the wiring connector will

function properly. Once installed, test for proper function by

using a test light or connecting a properly wired trailer.

PAGE 1 • 56394-INS-RA

PAGE 1
INSTALLATION INSTRUCTIONS WARNING: DO NOT EXCEED PRODUCT RATING OR TOW VEHICLE LAMP LOAD RATING, WHICHEVER IS LOWER APPLICATIONS Make Model Chevrolet Traverse WIRING LOCATION GUIDE SUVS, MINI & FULL-SIZED VANS (S) Representative vehicle shown below S5 - Behind driver side rear bumper CUSTOM WIRING CONNECTOR S5 NOTICE All steps must be followed to ensure the wiring connector will function properly. Once installed, test for proper function by using a test light or connecting a properly wired trailer.
PAGE 2
INSTALLATION / SAFETY INSTRUCTIONS Step 1 Above the muffler on the driver side, locate the vehicle taillight wiring. Lower the muffler to access the vehicle taillight wiring connector. Step 3 Insert the custom wiring connector end into the vehicle connector. Make sure the connectors are fully inserted with locking tabs in place. Note: It may be necessary to use the trim panel removal tool to pry the connector away from the vehicle frame.