Installation Guide

ManualsBrandsCURT ManualsOtherCustom Vehicle-Trailer Wiring Harness, 4-Way Flat Output, Select Volkswagen Golf GTI, Quick Electrical Wire T-Connector

56405-INS-RB

•

PAGE 1

INSTALLATION MANUAL

Wiring Location(s)

P3 and P4

Product Photo

Hardware Photo

Product Registration and Warranty

CURT Group stands behind our products with industry-leading warranties.

Provide feedback and help us to improve our products by registering your purchase at:

warranty.curtgroup.com/surveys

Maintenance

Periodic inspection of all wires and connections should be performed

to ensure there is no visible damage or loose connections.

Wiring Location Guide*

for Passenger Cars (P)

P1 Behind driver side taillight

housing, outside of trunk

P2 Behind passenger side taillight

housing, outside of trunk

P3 Behind driver side taillight

housing, inside of trunk

P4 Behind passenger side taillight

housing, inside of trunk

P5 Behind driver side rear bumper

P6 Behind center of rear bumper

P7 Behind passenger side rear bumper

P1 P3 P4 P2

P5 P6

* Representative vehicle shown

NOTICE

Before you begin installation, read all instructions thoroughly.

Proper tools will improve the quality of installation and reduce the time required.

All steps must be followed to ensure the product will function properly. Once installed,

test for proper function by using a test light or connecting a properly wired trailer.

Level of Difﬁculty

Moderate

WARNING

Do not exceed product rating or tow vehicle lamp load rating, whichever is lower.

The battery connection must be fuse-protected, 15-amp max. Exceeding

the product rating can cause loss of warranty, overheating and potential fire.

Electrical Ratings

Signal circuits 5.0-amps per side

Tail / Running Circuits 7.5-amps total

Check vehicle owner's manual or contact

the vehicle manufacturer for more information.

Tools Required

Ratchet Utility knife

Torx bit, T-20 Wire crimper

Torx bit, T-27 Wire stripper

Socket extension Panel trim

removal tool

Summary of content (4 pages)

PAGE 1
INSTALLATION MANUAL WARNING Level of Difficulty Do not exceed product rating or tow vehicle lamp load rating, whichever is lower. The battery connection must be fuse-protected, 15-amp max. Exceeding the product rating can cause loss of warranty, overheating and potential fire. Moderate Electrical Ratings Signal circuits Tail / Running Circuits 5.0-amps per side 7.5-amps total Product Photo Check vehicle owner's manual or contact the vehicle manufacturer for more information.
PAGE 2
Step 1 Locate the vehicle battery. Look up the battery location in the owner's manual of your vehicle. Disconnect the negative battery terminal. Be sure to fasten this wire down and away from the battery when completing the installation process. Step 2 Open the trunk. Remove all trunk floor coverings. Remove the fasteners securing the rear scuff panel. Remove the scuff panel by pulling out on the bottom and then up. Take care not to damage the alignment tabs on the back.
PAGE 3
Step 4 Locate a suitable grounding point near the connector such as an existing screw with nut in the vehicle frame or drill a 3/32" pilot hole for the provided screw. The area should be free of rust, dirt and paint. Secure the white ground wire using the ring terminal and provided screw. WARNING Check for miscellaneous items that may be hidden behind or under any surface before drilling to avoid damage and / or personal injury.
PAGE 4
POWERED CONVERTER LEAD INSTRUCTION SHEET FICHE DE CONSIGNES DU CONVERTISSEUR D'ALIMENTATION HOJA DE INSTRUCCIONES DEL CONDUCTOR DEL ADAPTADOR ALIMENTADO POR BATERÍA NOTICE AVIS / AVISO WARNING AVERTISSEMENT / ADVERTENCIA Illustrations are for reference only. Battery location may differ depending on the vehicle. To avoid personal injury or property damage, check for miscellaneous items that may be behind or under any surface before drilling. Les images ne sont fournies qu'à des fins de référence.