Installation Guide

56405-INS-RB
•
PAGE 2
Step 2
Open the trunk.
Remove all trunk floor coverings.
Remove the fasteners securing the rear scuff
panel. Remove the scuff panel by pulling out
on the bottom and then up. Take care not to
damage the alignment tabs on the back.
Step 3
Starting on the driver side, remove the
fasteners from the interior side trim panel.
Pull outward on the side trim panel to locate
the push fasteners behind the panel. Remove
the push fasteners from the side felt liner.
Pull back on the felt liner to locate the
vehicle taillight wiring harness connectors.
The connectors will be similar to those on
the custom wiring harness. Separate the
connectors from the taillight housing taking
care not to damage the locking tabs.
Insert the custom wiring harness end with
yellow wire between the separated connectors.
Make sure the connectors are fully inserted
with locking tabs in place.
Step 1
Locate the vehicle battery. Look up the battery location in the owner's manual
of your vehicle. Disconnect the negative battery terminal. Be sure to fasten this
wire down and away from the battery when completing the installation process.