Installation Guide

56405-INS-RB
•
PAGE 3
Step 4
Locate a suitable grounding point near the connector such as an existing screw with nut
in the vehicle frame or drill a 3/32" pilot hole for the provided screw. The area should be free
of rust, dirt and paint. Secure the white ground wire using the ring terminal and provided screw.
WARNING
Check for miscellaneous items that may be hidden behind or under
any surface before drilling to avoid damage and / or personal injury.
Step 5
Route the custom wiring harness end with the green wire down behind the interior
side felt liner and out to the passenger side behind the removed scuff panel.
Repeat step 3 on the passenger side using the harness end with the green wire.
Locate a flat spot inside the vehicle, near the taillight. Adhere
the black converter box using the provided double-sided tape.
Step 6
Route the black power wire from the vehicle battery as shown on the last page of this manual.
When in use, route the 4-flat to the center of the vehicle and out of the trunk. When not in use, roll up and
store in a convenient, out of the way location inside the trunk. Secure any loose wires with the provided cable ties.
Reinstall all items removed during install. If it was disconnected at the beginning of the installation,
reconnect the negative battery terminal. Install the provided 4-flat dust cover to help prevent corrosion.