Installation Guide

WARNING

Signal Circuits - 24-volt output / 2.1 amps per side

Tail / Running Circuits - 24-volt output / 7.5 amps total (24-volt)

Check vehicle owner's manual or contact

the vehicle manufacturer for more information.

This product is only compatible with 24V vehicle

wiring systems and 24V trailer wiring systems.

Using this product with a 24V vehicle wiring system and

standard 12V trailer can cause loss of warranty, lamp failures,

overheating and potential fire.

Do not exceed product ratings, trailer lamp ratings

or tow vehicle lamp ratings, whichever is lower.

Check for miscellaneous items that may be hidden

behind or under any surface before drilling to avoid

damage and / or personal injury.

INSTALLATION INSTRUCTIONS

24-VOLT TAILLIGHT CONVERTER

TESTING PROCEDURE

If testing with a 24V compatible test light, attach the ground

lead of the tester to the exposed ground wire of the trailer side

end. Activate the tow vehicle left turn, right turn, tail and brake

lights one at a time. Probe the three signal outputs of the trailer

side end to confirm proper functionality.

If testing with a 24V compatible trailer, connect the trailer and

run the same test as the circuit tester using the trailer lights.

If a function on the trailer lights does not work properly,

disconnect the trailer, turn functions on the vehicle off

and recheck function with a circuit tester. If functionality

is good, check the trailer for potential problems.

WARNING: DO NOT EXCEED PRODUCT, TRAILER OR TOW VEHICLE LAMP LOAD RATINGS, WHICHEVER IS LOWER

PAGE 1 • 56424-INS-RA

PAGE 1
INSTALLATION INSTRUCTIONS WARNING: DO NOT EXCEED PRODUCT, TRAILER OR TOW VEHICLE LAMP LOAD RATINGS, WHICHEVER IS LOWER 24-VOLT TAILLIGHT CONVERTER TESTING PROCEDURE If testing with a 24V compatible test light, attach the ground lead of the tester to the exposed ground wire of the trailer side end. Activate the tow vehicle left turn, right turn, tail and brake lights one at a time. Probe the three signal outputs of the trailer side end to confirm proper functionality.
PAGE 2
INSTALLATION Step 5 Locate a clean, accessible mounting location for the black converter box. If mounting outside of the vehicle, find a clean surface that is out of the path of spray and debris from the rear wheels and road surface. Step 1 Locate vehicle taillight wiring. Step 2 Using a 24V capable test lamp, probe or multi-meter, identify the corresponding wires in the harness for the left turn, right turn, taillights and brake lights.