Installation Guide

56434-INS-RA
•
PAGE 2
Step 1
Locate the vehicle battery. Look up the
battery location in the owner's manual of
your vehicle. Disconnect the negative battery
terminal. Be sure to fasten this wire down
and away from the battery when completing
the installation process.
Step 2
Open the vehicle trunk. Remove
the floor covering and rear cargo
area cover. Remove both side covers.
Remove the scuff panel by pulling out on
the bottom and then up. Take care not to
damage the alignment tabs on the back.
Step 3
Locate the push fasteners on the top of the
lower sidewall trim. Using a small flathead
screwdriver, release the push fastener lock
and pull out. Repeat this process on the
passenger side.
Using a 10mm socket, remove the cargo hook
and the bolt inside the mounting hole for the
hatch security visor. Repeat this process on
the passenger side.