Installation Guide
56434-INS-RA
•
PAGE 3
Step 4
On the driver side, use a panel trim removal
tool to release the side panel fasteners from
the bottom up. Release the lower side wall
trim from the upper side wall trim. Pull back
the lower side wall panel.
Locate the taillight wiring harness. The
connectors will be similar to those on your
new custom wiring product. Separate the
connectors from the taillight housing taking
care not to damage the locking tabs.
Insert the custom wiring end with yellow wire
between the separated connectors. Make sure
the connectors are fully inserted with locking
tabs in place.
Step 5
Locate a flat spot inside the vehicle, near the
taillight. Adhere the black converter box using
the provided double-sided tape.
Locate a suitable grounding point near the
connector such as an existing screw with nut
in the vehicle frame or drill a 3/32" pilot hole
for the provided screw. The area should be free
of rust, dirt and paint. Secure the white ground
wire using the ring terminal and provided screw.
WARNING
Check for miscellaneous items that may be
hidden behind or under any surface before
drilling to avoid damage and / or personal injury.
Step 6
Route the custom wiring end with the green
wire to the passenger side behind the removed
scuff panels. Repeat step 4 on the passenger
side using the wiring end with the green wire.
Step 7
Route the black power wire from the vehicle battery as shown on the last page of this manual.
NOTICE
Once 12 volt power wire is connected to the harness verify that the harness is functioning
by attaching the battery and testing with a test light, 4-flat tester, or a functioning trailer.
When in use, route the 4-flat to the center of the vehicle and out of the trunk.
When not in use, roll up and store in a convenient, out of the way location
inside the trunk. Secure any loose wires with the provided cable ties.
Reinstall all items removed during install. If it was disconnected at the beginning of the installation,
reconnect the negative battery terminal. Install the provided 4-flat dust cover to help prevent corrosion.