Installation Guide

WARNING

Signal Circuits - 3.0 amps per side

Tail / Running Circuits - 6.0 amps total

Check vehicle owner's manual or contact

the vehicle manufacturer for more information.

The battery connection must be fuse-protected, 10-amp max.

Exceeding the product rating can cause loss of warranty,

overheating and potential fire. Do not exceed product rating

or tow vehicle's lamp load rating, whichever is lower.

Check for miscellaneous items that may be hidden

behind or under any surface before drilling to avoid

damage and / or personal injury.

TESTING PROCEDURE

If testing with a test light, attach the ground lead of the tester

to the exposed ground terminal of the 4-flat end. Activate

the tow vehicle left turn, right turn, tail and brake lights one

at a time. Probe the three receptacles of the 4-flat end to

confirm proper functionality.

If testing with a trailer, mate the 4-flat with the trailer and

run the same test as the circuit tester using the trailer lights.

If a function on the trailer lights does not work properly,

disconnect the trailer 4-flat, turn functions on the vehicle

off and recheck function with a circuit tester. If functionality

is good, check the trailer for potential problems.

ALL STEPS MUST BE FOLLOWED TO ENSURE PROPER FUNCTION OF THE TAILLIGHT CONVERTER

TAILLIGHT CONVERTER

INSTALLATION INSTRUCTIONS

PAGE 1 • 56496-INS-RB

PAGE 1
INSTALLATION INSTRUCTIONS ALL STEPS MUST BE FOLLOWED TO ENSURE PROPER FUNCTION OF THE TAILLIGHT CONVERTER TAILLIGHT CONVERTER TESTING PROCEDURE If testing with a test light, attach the ground lead of the tester to the exposed ground terminal of the 4-flat end. Activate the tow vehicle left turn, right turn, tail and brake lights one at a time. Probe the three receptacles of the 4-flat end to confirm proper functionality.
PAGE 2
WIRING LOCATION GUIDE Representative vehicles shown below - DS, driver side / PS, passenger side PASSENGER CARS (P) SUVS, MINI & FULL-SIZED VANS (S) PICKUP TRUCKS (T) P1 - Behind DS taillight housing, outside of trunk S1 - Behind DS taillight housing T1 - Behind DS taillight housing P2 - Behind PS taillight housing, outside of trunk S2 - Behind PS taillight housing T2 - Behind PS taillight housing P3 - Behind DS taillight housing, inside of trunk S3 - Behind DS rear access panel T3 - Behind DS r
PAGE 3
INSTALLATION Step 1 Locate vehicle taillight wiring. Refer to the wiring location guide on the second page. Step 2 Identify the wiring type of your vehicle using the 'How to Determine Vehicle Wiring Types' instructions on page two. Step 3 Locate vehicle battery and disconnect the negative battery terminal. Step 4 Using snap locks, attach the input wires of the taillight converter to the corresponding vehicle harness wires identified in Step 2 using the 'Wiring Installation' table below.