User Guide

Instruction sheet

Figure 1

Figure 2

Under-bed mount

60601 gooseneck ball

Truck bed

60617 safety chain loops shown properly installed

Always install both safety chain loops in rear-most under-bed mounts

Safety chain

anchor

Periodically check all gooseneck components to ensure that

fasteners are tight and that structural components are sound.

Vehicle performance, such as braking, handling,

acceleration and turning radius, can be drastically

affected by the trailer. Allow additional time and space

for stopping, changing lanes, passing and turning.

Do not tow more than one trailer at a time.

This may cause loss of control.

Severe bumps can damage your towing system.

Avoid or drive slowly over rough terrain.

WARNINGS

WARNING: NEVER EXCEED YOUR VEHICLE MANUFACTURER S RECOMMENDED TOWING CAPACITY

INSTALLATION INSTRUCTIONS

RAM FACTORY-STYLE GOOSENECK

BALL AND SAFETY CHAIN ANCHORS

PARTS LIST

Item Qty Description

1 2 Safety chain anchor

2 2 12mm pin

3 2 5mm lynch pin

4 1 Gooseneck ball

5 1 Rubber cover

6 1 Case

PAGE 1 • 60618-INS-RB • 1.800.798.0813 • NEED ASSISTANCE? • CURTMFG.COM

PAGE 1
INSTALLATION INSTRUCTIONS WARNING: NEVER EXCEED YOUR VEHICLE MANUFACTURER S RECOMMENDED TOWING CAPACITY RAM FACTORY-STYLE GOOSENECK BALL AND SAFETY CHAIN ANCHORS 2 3 1 4 5 Instruction sheet PARTS LIST Item Qty Description 1 2 Safety chain anchor 2 2 12mm pin 3 2 5mm lynch pin 4 1 Gooseneck ball 5 1 Rubber cover 6 1 Case 6 3 Figure 1 2 1 Under-bed mount 60601 gooseneck ball WARNINGS Truck bed Periodically check all gooseneck components to ensure that fasteners are tight and
PAGE 2
60601 OPERATION Step 1 To install the 60601 gooseneck ball, lift the handle from its seat and rotate 90°. Insert the gooseneck ball into the receiver tube in the bed of truck. Rotate the handle to the locked position and flip it down into its seat. See figure 3. Truck bed Note: If handle does not freely rotate into the locked position, rotate the ball while applying light pressure to the side of the handle. When the handle rotates into the locked position flip it down into the seated position.
PAGE 3
BEFORE TOWING FOR THE FIRST TIME BEFORE TOWING EVERY TIME Verify adequate turning clearance between the truck cab / box corners and trailer(s). Ensure all fasteners are tight and that all structural components are sound. Note: Do not tow trailer with worn or damaged parts. Check truck box clearance. There should be a minimum clearance of 6" between the bottom of the trailer(s) overhang and the top of the box sides. Verify all anchors are properly installed and secured with lynch pins.