User Guide

ManualsBrandsCURT ManualsAutomotiveCurt 60618 Puck System Gooseneck Ball & Safety Chain Anchor Kit for Ram

Figure 5

Figure 6

Figure 7

Figure 4

Figure 8

Figure 3

Rear-most under-bed

mount (both sides)

Both rings should face

the center of the truck

Truck bed

Handle must match

the ball proﬁle while

in the locked position,

prior to coupling

Receiver tube

Seat

Unlocked Locked

Handle

Rotated 90°

Locked

60601

Keep the 60601, receiver, trailer coupler and 60617 safety

chain anchor pins lubricated. Use silicone spray

or equivalent to prevent wear and rust.

Keep the 60601, receiver, trailer coupler, anchors and

under-bed truck mounts free of dirt and other foreign debris.

Note: Failure to maintain your towing system could

result in poor performance and / or catastrophic failure.

MAINTENANCE

Step 1

Align safety chain anchor with the rear-most under-bed

mount on both sides. See figure 5. Note: Always install both

safety chain anchors in the rear-most under-bed mounts.

Step 2

Lower safety chain anchor into under-bed mount and rotate

90° toward the center of the truck. See figures 5 and 6.

Step 3

Insert 12mm pin into the top of the safety chain

anchor and lock into position using the 5mm lynch pin.

See figures 7 and 8. Note: Both the 12mm pin and 5mm

lynch pin must be fully inserted and engaged.

Step 4

When safety chain anchors are not in use, remove from the

under-bed mounts and store in the case, in a dry, clean area.

Step 1

To install the 60601 gooseneck ball, lift the handle from

its seat and rotate 90°. Insert the gooseneck ball into the

receiver tube in the bed of truck. Rotate the handle to the

locked position and flip it down into its seat. See figure 3.

Note: If handle does not freely rotate into the locked

position, rotate the ball while applying light pressure to the

side of the handle. When the handle rotates into the locked

position flip it down into the seated position.

Step 2

When the gooseneck ball is not in use, remove it from the

receiver tube and store it in the case, in a dry, clean area.

Step 3

Place the rubber cover (66155) in gooseneck receiver

when the ball is removed to keep dirt and contaminates out.

60617 OPERATION

60601 OPERATION

CURTMFG.COM • NEED ASSISTANCE? • 1.800.798.0813 • 60618-INS-RB • PAGE 2